If you want to use CwGet in both Entry windows, it should be a registered copy.
Cw Reader Decoder Serial Or ParallelThe CW reader engine cannot be used to transmit CW; to transmit CW, you must configure some other method in the Logger (serial or parallel port keying, or a Winkeyer, for example).Cw Reader Decoder Download And InstallFldigi is not automatically installed with N1MM Logger; if you want to use it, you must download and install it.Once fldigi has been downloaded (and optionally configured for digital mode operation see the Digital Fldigi for Sound Card Modes chapter), it can also be used as a receive-only CW reader (N1MM Logger does not support transmitting CW from fldigi).Click on the Enable check box for Fldigi and set up the location of the fldigi.exe file you are using as a CW reader. You should create a separate folder for the fldigi CW reader and copy fldigi.exe from the main fldigi installation folder into this separate folder. You may wish to use a separate copy of fldigi for CW from the N1MM digital modes copy as well; that way, the configuration setups for fldigi for CW and for digital modes can be saved separately. Both of these copies of fldigi should be outside the Program Files or Program Files(x86) paths in Windows Vista or later, in order to enable the configuration files to be saved. Although you can run fldigi stand-alone from a location in the Program Files path, any copy of fldigi that is run from N1MM Logger in Windows Vista or newer must not be located in a protected Program Files path. When you first install fldigi, you do not need to do the original installation of fldigi outside the Program Files path. Simply install in the default location, create a new location outside the Program Files path, and copy the fldigi.exe file from the original installed location into the new location. The first time it is run from the Logger, fldigi will create the other files it needs in the new location. ![]() In either case, after downloading and installing CwGet you can select it in the CW Reader setup window by checking the Enable check box for CW Get and entering the path to the program. It is also possible to select command line settings for CwGet in the setup window. Unlike fldigi, CwGet may be run from the default installation location even if that location is in C:Program Files or C:Program Files(x86). You do not need to make a separate copy of CwGet outside the Program Files path. You set up the COM port communications parameters for the TNC in the bottom part of the window. This will open one or two new windows: the CW reader engine window (if you are using fldigi or CwGet) and the CW Reader text window (see next section). There will be further configuration required in the CW reader engine window the first time it is used (or every time if you are using an unregistered copy of CwGet), in order to select the sound card that is used for decoding. The fldigi configuration window may open the first time you use it; if it does, the first part of the configuration information that is needed for the CW Reader engine is the sound card setup. You also need to ensure that rig control and PTT control are both disabled in fldigi. The first time fldigi is used as a CW reader engine, it may start up in a digital mode and you may need to change its operating mode to CW. The CW Reader window corresponding to each Entry window is opened from the Window CW Reader menu item in that Entry window. In order to save separate configurations for the fldigi engines in the two CW Reader windows, you will need to use two separate copies of fldigi, one for each CW Reader window.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |